[hpsmithParticipant]

To my knowledge not from a softkey. I would rather prefer an option to have the PAFL post-fader but pre-mute

[hpsmithParticipant]

Hi,

I have tried a couple of USB 3.0 sticks. The desk does not recognize them at all. We have one of the early hardware versions and not sure if the newer desks support USB3.0

[hpsmithParticipant]

+1
We popped the HF protection units in the speakers a few weeks ago when the desk was switched on after a power failure. During ‘normal’ shutdown I told the team to mute all channels before shutdown.

[hpsmithParticipant]

I found that even if you change the IP from the default it takes longer to boot. (192.168.1.50)
v1.3

[hpsmithParticipant]

quote:

---

Originally posted by bvde

Here some other improvements:

– Our GLD80 is fixed installed. There is one switch that starts the amplifiers and the snake. When doing this, a loud *plop* is heard, due switching the phantompower. Please switch on start-up the relays to the outputs 5 seconds after the setup is loaded and the phantompower is switched on.

---

Hi. A tip I found somewhere on a forum and works well is to create a seperate scene with all the channels and outputs on mute. Save this as something like ‘Shutdown’ and recall this scene before powering down the desk. When starting up again, no pop.[]. I actually moved all the fader to the bottom as well leaving the desk neatly for the next service.

Regards,
Hennie
GLD-80, AR2412, AR84

[hpsmithParticipant]

In our church we have been using the GLD for 6 months and would start using the libraries to save the individual vocalist channel. In saving the name and color with the channel would make it very easy to recall from USB each vocal thus I would add my vote for this feature. []

Regards,
Hennie
GLD-80, AR2412, AR84

[Author]

Posts