Forum Replies Created
Viewing 4 posts - 1 through 4 (of 4 total)
Viewing 4 posts - 1 through 4 (of 4 total)
I am looking at getting 2 optogates to help control this system,
Ducker Setup Idea
Inputs:
1. Altar
Duck Input Source Mix 2 (Media)
2. Reader
Duck Input Source 4 (Handheld)
3. Lectern
Duck Input Source Mix 2 (Media)
4. Handheld
Duck Input Source Mix 2 (Media)
5. Organ
6. Vox
Organ
Airplay
CD > MIX 2
Aux
Projector
Altar & Lectern > MIX 3 >Input15
Duck Input Source 14
Reader & Handheld > MIX 4 > Input 14 Duck Input Source 15
Thanks for all these suggestions. Is there any way to route the Mics on the qu16 to get them to duck each other to assist and would you suggest a harshish compression ?
Thanks for that, I have applied the duck and will see how it goes. As you suspected No there is no operator. I was thinking about Sending all the Music Sources (CD and Organ and Airplay) into a Mix then Back in as a Input therefore i could duck from that source.
Only One of the Podium Mics may sometimes have someone speaking when the organ is playing, so i left no ducking on that mic. It appears after some investigation that someone had turned the organ up louder than normal which was the source of feedback (I was not there so i am only going from word of mouth). I also tried playing some tracks loudly to try and get the Mics to feed with No Luck. No FX are being used so i don’t mind loosing the FX for being able to Duck.
When i say the room feels live with the Mics Open the Church is a Concrete Building with about a natural reverb of 2 / 2.5 seconds and you hear the air and general room noise when the mics do not have a gate. They would prefer not to put mute switches in place.
If you Switch Off all the Gates there is a Slight Ring to the Room but no Feedback Takes Off, The Gates are being used to Stop the Mics which are always live having room ambience in them all the time. Its only having the higher SPL of the Organ which opens all the gates and then the room seems to take off.
Hope this describes the situation a bit better. I can stop the feedback by muting one mic that is open, ultimately i would like to try and setup the mics to act similar to a auto mixer.
Thanks Again