Shure integration

Forums › Forums › dLive Forums › dLive General Discussions › Shure integration

Tagged: 

This topic contains 2 replies, has 2 voices, and was last updated by Profile photo of Ilrusso Ilrusso 5 years, 4 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • 2018/12/21 at 10:56 pm #81006
    Profile photo of Ilrusso
    Ilrusso
    Participant

    Hello,

    today I connected our qlxd’s to our mixrack. I gave a static IP to each of them and the dlive had no problems to find them over the network. I assigned them to the corresponding channels, everything was fine.
    but when I select the preamp page of these channels, I see the RF info but everything is blank: no battery level, no RF signal is shown.
    Am I doing something wrong?

    Does it require a specific shure receiver firmware version as a minimum requirement?

    Thanks.

    2018/12/25 at 7:20 am #81072
    Profile photo of
    Anonymous

    Did you go through the documentation here?
    https://www.allen-heath.com/media/dLive-Shure-Integration-Guide-ISS1.pdf

    2018/12/25 at 2:47 pm #81076
    Profile photo of Ilrusso
    Ilrusso
    Participant

    Thanks.
    yes, I did it twice…
    …and the second time I recognized this:

    Assigning static IP addresses requires a device reboot. 😬🙈

    Now it works…

    Thank you

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.