Sample rate change Logic Pro X

[debzdoodle]

I use Logic Pro X and my QU16 as my interface. Please understand although I have been recording for some time, I used Garageband for many years ( with some good results) but I started using Logic Pro X this past year. I don’t very much – I mainly run live sound so I am still learning a lot and probably will never need what LP offers.
However, I recently did some recording having last down drums and bass and on one tune I forgot to change the sample rate from 44.1khz to 48khz. I would like to make that change before any other tracks are added. If I try to change in project settings, any tracks that have more than one region in them do not shrink up correctly. Everything else does. How can I correct this?
Again please understand my limitations in getting around Logic Pro X.
Thank you

[Andreas]

Maybe that’s better asked in a Logic Pro Forum?

[debzdoodle]

I did post there too Andreas but I figured it was worth a try here as I am already a member and in case someone had an answer for me.

[Author]

Posts