Rack mounting DX168 or AB168

Forums › Forums › SQ Forums › SQ general discussions › Rack mounting DX168 or AB168

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • 2019/01/16 at 11:37 pm #81444
    Profile photo of BarryjamBarryjam
    Participant

    When one rack mounts a DX168 or an AB168 with the optional rack ears, must you remove the rubber bumpers first or do the rack ears fit in between those rubber bumpers?

    Barry

    2019/01/16 at 11:55 pm #81445
    Profile photo of GCumbeeGCumbee
    Participant

    They are removed

    2019/01/17 at 12:04 am #81447
    Profile photo of BarryjamBarryjam
    Participant

    Ahh, Thanks.

    That means you don’t get that little space on the top or bottom to route cables to the back of the rack. Good to know.

    2019/01/17 at 12:08 am #81448
    Profile photo of GCumbeeGCumbee
    Participant

    I’ve done a couple but it’s been awhile. I think there was a gap top and bottom. I know I ran a short Ethernet jumper through to the front of the ME-U

    2019/02/14 at 2:46 am #81951
    Profile photo of MVickeryMVickery
    Participant

    The rack ears extend below the bottom of the Dx168. The space and this creates is just tall enough to get XLR connectors through.

    2019/02/14 at 3:15 am #81952
    Profile photo of BarryjamBarryjam
    Participant

    Thanks for the update, MVickery!

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.