QU 16 channel stopped working

[EmeraldT]

Hi, Channel 9 on my QU 16 is accepting signal which I can hear in my monitor mix as normal but output to LR has stopped. Nothing to FOH

I run a simple band mix which barely changes and (to my knowledge) I haven’t touched anything which might have caused this loss of output to LR

Any ideas or suggestions would be appreciated.

Robert

[MarkPAman]

Is it (Ch9) still assigned to L+R. Can be relatively easy to change this by mistake – especially when using QuPad.

Press the “Assign” button on the desk & check that the select button of ch9 is lit.

Page 22 of manual

[Anonymous]

If there is signal to a mix then assign is easily the most likely culprit.

[EmeraldT]

This is exactly what it was, thank you both for your help. Brilliant.

[Anonymous]

Thanks for reporting back 😉

[MarkPAman]

+1 🙂

[dpdan]

nine times out of ten it was inadvertantly turned off on the iPad,,, not the console

[EmeraldT]

Yes that is likely to be what has happened as I definitely didn’t mess with that screen on the console

[Author]

Posts