Panning gets lost in groups?

Forums Forums SQ Forums SQ troubleshooting Panning gets lost in groups?

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #111956
    Profile photo of Some1elseSome1else
    Participant

    Hi there all over the planet,

    I am coming from from Qu-16 and yesterday I have received my brandnew SQ5. First I updated the Firmware to 1.5.8
    Device is running properly so far. Í am facing an issue with losing the panning when I route a Signal via a group to Main L/R.
    I have three guitar signals. One is panned to the left, one is panned to the right and the third one in the mid. When I route the channels straight to Main L/R the panning works properly. But when I unroute the Guitar signals from the Main L/R and route the guitars into a Group and then route the Group to Main L/R, all my panning gets lost and all guitars can be heard similar from both Main L/R Channels, no matter what I do on the panning knob.
    Where do i do the mistake?

    Appreciate your support

    Kind regards from Germany
    Andy

    #111958
    Profile photo of ioTonioTon
    Participant

    Hi Some1else,

    Maybe you configured the Bus as a Monobus.

    Goto “Setup -> Mixer Config -> Mix Stereo”
    define you group as Stereo, and anything should be fine!

    Kind regards from Austria,
    dd

    #111959
    Profile photo of Some1elseSome1else
    Participant

    Yesss there we go 😃

    Next beer is on me man!!

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.