Pan in scene

Forums › Forums › iLive Forums › iLive troubleshooting › Pan in scene

This topic contains 3 replies, has 2 voices, and was last updated by Profile photo of Underscore Underscore 7 years, 3 months ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • 2017/01/20 at 5:29 pm #60770
    Profile photo of ambulance23
    ambulance23
    Participant

    Is it possible to save only data for pan in a scene?

    2017/01/21 at 12:35 am #60771
    Profile photo of Underscore
    Underscore
    Participant

    The ‘pan’ data is part of the “sends and routing” process when you save your scene, but is part of the ‘image’ tab under the scene safes page.
    If your input channel ‘image’ is scene safe, your pan setting will not recall, but also take note of any aux output routing changes that you may or may not change as it will also be stored in your scene.

    2017/01/21 at 10:40 pm #60794
    Profile photo of ambulance23
    ambulance23
    Participant

    Is there a way to set only my aux sends scene save? If I understand you right, the result is only recal pan from that scene.

    2017/01/22 at 4:18 am #60797
    Profile photo of Underscore
    Underscore
    Participant

    Yes, your aux routing can be set scene safe if you want it to be.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.