@willmodelisme
No expert on MS but this is how I got DCA working:
In settings/layer hit the “+” to add a new layer.
It’ll show a screen where you add what you want channel wise.
On that same page hit the “+” again and add IDCA.
Then you’ll have a screen to add the channels you want on that IDCA.
If you hit the IDCA button on the top of that screen you’ll be able to rename it.
Skip back now to main mixer view and select your new layer on the right hand side where you see “Fine, Mix, FX send” etc.
Now you’ll find the IDCA slider and it’ll be linked to the channel selection.
If you touch the top of the IDCA tab you’ll bring up the allocation page again where you can edit your selection!
Hope that helps!
Haven’t set up mute groups yet!
.
.
