Mix & LR volume level

Forums Forums Qu Forums Qu general discussions Mix & LR volume level

This topic contains 5 replies, has 4 voices, and was last updated by Profile photo of dpdan dpdan 4 years, 5 months ago.

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #62360
    Profile photo of Mirko26
    Mirko26
    Participant

    Hello,

    I have a question for you : I have 3 monitor speakers, when I change the volume from MIX
    it’s ok, and it doesn’t change the LR volume, but, if I change LR volume, change the monitor’s volume as well!
    How can I make them indipendent from LR?

    Please help me!

    Thank you in advance!

    Mirko.

    #62361
    Profile photo of Dick Rees
    Dick Rees
    Participant

    Sounds like you’ve got a routing problem or you’re not where you think you are as to which bus you’re working on.

    Things to check:

    1. Pre/post assignments on Mix buses.

    2. Control group or DCA assignmnts.

    3. Bus channel assignments.

    #62362
    Profile photo of Mirko26
    Mirko26
    Participant

    ok, I’ll check.

    Thanks a lot!

    #62367
    Profile photo of Mirko26
    Mirko26
    Participant

    Mh…Now I’m thinking that I keep always the monitor’s pre off…

    Tomorrow I’ll try to turn on it.

    Maybe the problem is that.

    Thanks in advance!

    #62387
    Profile photo of [XAP]Bob
    [XAP]Bob
    Participant

    Monitors should be prefaced, sounds like they are post fade

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.