Me500 and qu16

Forums Forums ME Forums ME general discussions Me500 and qu16

This topic contains 2 replies, has 2 voices, and was last updated by Profile photo of joeymauro joeymauro 5 years, 7 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #73486
    Profile photo of joeymauro
    joeymauro
    Participant

    I have a qu16 and an me500. I plugged into the dsnake port and the me500 works. However it only works post fader. Any way to make the me500 work pre fader in this setup? Thanks.

    #73491
    Profile photo of Underscore
    Underscore
    Participant

    https://www.allen-heath.com/media/Qu-Mixer-Getting-Started-Guide-AP10025_2-V1.9.pdf

    page 16

    You have to change the direct out settings, this is a global change.

    #73501
    Profile photo of joeymauro
    joeymauro
    Participant

    Thank you so much. It worked perfectly. Why on earth Allen and Heath thought putting those GLOBAL settings under each channel boggles my mind. Thanks again.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.