GLD Failed to program DSP

Forums › Forums › GLD Forums › GLD troubleshooting › GLD Failed to program DSP

Tagged: 

This topic contains 2 replies, has 3 voices, and was last updated by Profile photo of Mike C Mike C 1 year, 7 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • 2021/03/31 at 10:42 am #100273
    Profile photo of schalkvanstaden
    schalkvanstaden
    Participant

    Hi

    The GLD at the church I worked for died a few years ago and I’m trying to see if I can revive it without needing to spend a few hundred/thousand dollars. What basically happens is I get an error that says “Failed to program DSP”. I’ve attached the logs. I’ve tried the “White screen of death fix”, swopped out USB cables, and tried a firmware reload. Any ideas of what I can try before I can write it off as a hardware failure.

    Thanks!

    2022/09/26 at 2:48 am #109207
    Profile photo of Ulis
    Ulis
    Participant

    Same problem

    2022/09/27 at 12:17 am #109222
    Profile photo of Mike C
    Mike C
    Participant

    Dead BIOS/mother board battery.

    You’ll find post about changing that here.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.