Channel Routing with Dante – ilive for DAW

Forums › Forums › iLive Forums › iLive troubleshooting › Channel Routing with Dante – ilive for DAW

Tagged: , ,

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • 2022/05/26 at 6:10 pm #107308
    Profile photo of JuneJune
    Participant

    Hello All,

    I’m a sound tech at my House of Worship. We wanted to be able to mix the live stream separately and mulit-track record, but of course the budget wouldn’t allow us to go new.

    We have the T-112 ilive with an XDR 16 which is where Dante is installed.

    I have set up everything correctly with Dante controller, and the amount of channels etc, routed the channels and see signal in LOGIC pro… HOWEVER..

    The signal is low on some channels and HOT in others… it seems as though the levels are still controlled by the t112?

    how can i port out to dante – pre fader? or how can i ensure they are separated (moving levels on house mix won’t effect what i’m doing on laptop)

    Thanks
    June

    2022/05/26 at 11:52 pm #107318
    Profile photo of SteffenRSteffenR
    Participant

    Use direct outs without fader influence… should be a setting.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.