USB Recording

Forums › Forums › GLD Forums › Archived GLD Discussions › USB Recording

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • 2012/05/15 at 6:24 pm #23152
    Profile photo of Mike-MullinMike-Mullin
    Participant

    I know this has been mentioned before but…
    Can someone explain to me why on two different
    shows I have recorded empty wave files.
    There is nothing in the manual or the help files
    about routing for the purposes of recording.
    I don’t get it….

    2012/05/15 at 6:43 pm #30593
    Profile photo of CareyDCareyD
    Participant

    Hi Mike,
    The source to the USB recording is assigned using the ‘I/O’ screen ‘Surface’ tab. You assign this in the same way as assigning the output sockets. In the GLD Template Shows, Matrix 1 is assigned as default. The Matrix 1 master is on fader strip Bank 2 Layer D and is labelled ‘Rec’. Raise the fader to send signal to the recording.
    Regards,
    Carey

    2012/05/15 at 11:47 pm #30596
    Profile photo of Mike-MullinMike-Mullin
    Participant

    Thanks Carey.
    Cheers,
    Mike

    2012/10/14 at 1:04 am #31688
    Profile photo of Anonymous
    Inactive

    Hi Carey
    Is this done on the t112 we are just installing it in our church

    Chuck

    2012/10/15 at 2:27 pm #31705
    Profile photo of Anonymous
    Inactive

    Adding a meter on the USB record screen would also be great, so you know when the signal is routed correctly to the USB and recording. You basically have to record a bit, play it back to make sure it is all correct and then record.

    meter would solve this, to know routing is correct.

    Carl.

    2012/10/15 at 7:19 pm #31706
    Profile photo of TJCornishTJCornish
    Participant

    quote:

    Originally posted by Chuck

    Hi Carey
    Is this done on the t112 we are just installing it in our church

    Chuck

    I don’t believe there’s any recording capability on the iLive.

    2012/10/15 at 10:23 pm #31708
    Profile photo of Chris93Chris93
    Participant

    Meters would be handy, but you can check that you are sending signal to the flash drive by (p)AFL’ing the mix you have set the USB record to source it’s signal from (I/O, Surface) . It doesn’t check that it’s actually being recorded but if Matrix 1 has signal and the USB is set to record from Matrix 1 …

    My main issue is with having to mentally subtract 18 from all the meters. Getting good at it though. [;)]

    Chris

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • The forum ‘Archived GLD Discussions’ is closed to new topics and replies.