Forums › Forums › Qu Forums › Qu troubleshooting › Layer selection indicator lights… › Reply To: Layer selection indicator lights…
2015/11/30 at 6:41 am
#52381
dpdan
Participant
I am not speaking for A&H here, but light emitting diodes can vary so much even in a very strict, specified tolerance that A&H demands from the manufacturer (factory). Even close tolerance LEDs can sometimes have this exact behavior with limiting the voltage to them for the purpose of dimming. In my opinion, there is nothing wrong with your mixer, and there really is nothing that can be done at this point to expect identical brightness between the various LEDs.
.02
your milage may vary 🙂