Forum Replies Created
Viewing 12 posts - 1 through 12 (of 12 total)
Viewing 12 posts - 1 through 12 (of 12 total)
Hi,
Allen & heath : when the firmware 1.52 will come out ?
It s really long…
Thanks
1 year and still no update…
When the 1.52 firmware go out ??
Thank you
Hi,
Yes thank you.
I see this topics before when i have buy my switch and i have buy the model of “Take Note”:
“BV-Tech. POE-SW801. 8 port Poe switch. $80.00 on Amazon. It works great.”. But with me it’s not work 🙂
I try to buy Edimax GS-1008P and i hope it will work…
Thanks
Hi take note,
I buy this switch for my me 1, and i have clicking problem when i use.
Do you have a same problem ?
Thanks
Sorry but i see the different switch, and i don t understand the problem with the power of my switch.
My switch power budget is 150w, so i think it s normally a good caracteristics ?! No ?
And with only one me 1 i have the problem…
Do you think this switch is good :
Thank you
Hi,
Ok thanks.
I search a poe switch with this caracteristics.
If you know a model which works with me1, please contact me.
Thanks a lot.
Hello,
Thanks for your response.
I test a capture wireshark (see attachments…)but i don’t see any packets that are not from the A&H …
Is there any clicking if you plug an ME-1 directly into your mixer? No, when i powered ME1 directly, i have not this problem.
I have this problem only with my switch, and it is not a manageable switch.
Do you know another model of POE switch for ME1 ?
Thanks
Thomas
Hello,
I have the same problem today with my 4 ME-1.
My switch is: BV-Tech 8 Port & 1 port uplink, 150 W 10/100Mbps, sw801 PoE Switch
https://www.poedepot.com/poe/switches/bv-sw800e-8-port-120w-network-power-over-ethernet-switch.html
I do not find the Trendnet TPS-88e…
Do you have a switch POE model is working with ME-1 ?
Thanks a lot.
Ok.
Thank you
Hello,
Do you know when is that a update will fix this problem ?
Because saving the differents scene when i change strip assign, is a error source …
Thank you !
I did the same test with GLD editor in Windows and i have the same reaction.
I don’t understand why ?!
Hello,
First of all I apologize for my English, I am French people.
I have the same problem !
I have a GLD 80 with “GLD FIRMWARE RELEASE 1.51” and when i add strip assign and i recall a scene recorded before, my strip assignment not disappear, but when, i reboot gld80 and i recall the same scene the strip assignment disappear.
In the “safe scene” I have safe all parameter.
Do you have an idea for the origin of my problem ?
Thanks a lot.
Thomas