Thanks to the both of you for the sanity check.
This is the same across all inputs, and the preamp must be set at +60 (Full) to get be able to operate around the 0 fader position. (I believe 12 oclock on the preamp gain is +30)
Most mics are the RE16 used as interview/discussion use with handheld microphones, so no more than about 6 inches away.
One mic is a Shure MC412 podium mount(phantom powered condenser) and this is run around +54.
I was wondering if there was some system wide input level setting I was missing? (It is as if we are plugged into a line level input) The system has been operating like this from the time it was installed more than a year ago and this has been accepted as “just the way it works”.
Any ideas would be appreciated.
Tom