Forum Replies Created

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • 2013/12/21 at 6:23 pm #36960
    Profile photo of nissse
    nissse
    Participant

    I think their statement is a bit strange.
    If you look at the CAT6 standard, it states that it must be backward compatible with CAT5e.
    The CAT6 standard is better for crosstalk and better transmission performance. If you look inside the CAT6 cable, the pairs are separated with a plastic X, which makes it thicker.
    All and all, I don’t think you will notice any difference.
    I’ve run on all strange sorts of cables including a cheap 25m unshielded CAT5e that I’ve got with my broadband.

    Just my 5cent
    /Christian

    2013/08/17 at 8:08 am #34649
    Profile photo of nissse
    nissse
    Participant

    It should work as in A&H TCP MIDI Driver Installer.
    And you can use an ethernet cable direct
    You can find it under firmware and software downloads.
    I’m also setting this up and are going to use Dante as soundcard.

    /Christian

    2013/06/19 at 11:06 pm #34268
    Profile photo of nissse
    nissse
    Participant

    Well now I got problems with my PL-6.
    The RJ-45 input connector seems to have some bended pins.
    I bought some new and I’ll think I’m going to change them this weekend.

    Christian

    MobileMusic
    iDR-48, iDR-16, xDR-16, T112, T80
    PL-6, MixPad, Tweek, OneMix

    2013/02/05 at 1:21 am #32975
    Profile photo of nissse
    nissse
    Participant

    According to the pl-6 user guide AP5197 page 2, section “Grounding” The exposed metal panels are grounded through the PL-Anet cable shield. It’s also reads: Use flame retardent CAT5 STP (shielded twisted pair) RJ45 cables.

    Well there I sounded like a school teacher, but we don’t have any problems with our pl-6, but we always use a shielded cable.

    https://www.allen-heath.com/UK/Products/Pages/ProductDetails.aspx?filename=DocumentMaster/uk/pl-6_ug_ap5197_4.pdf

    MobileMusic
    iDR-48, iDR-16, xDR-16 T112, T80
    PL-6, MixPad, Tweek, OneMix

    2012/07/30 at 9:59 pm #31090
    Profile photo of nissse
    nissse
    Participant

    We had a similar issue a couple of months ago and hasn’t reproducet it.
    One of the faders wen’t up and down quite fast like it had spasms.
    It was during a show and luckily nothing was on that channel for the moment.
    We had the wireless router unplugged almost immediately and suddenly it stopped, not sure that it was the router that interfered.

    2012/02/12 at 8:23 pm #30219
    Profile photo of nissse
    nissse
    Participant

    +1 for Dual mix rack setup in offline mode

    /Christian

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)