Forum Replies Created
-
hej guys,
i would appreciate for some help. I can’t seem to get to work foh/mon split via dante. I record via dante so i know how it works. Both dantes and my macbook pro are connected to trendnet teg-s5g gigabit switch. Everything is showing in dante controller. I named these two cards as idr10 and idr32. I want to set up idr10 and 144 surface as the master and it goes to FOH. Under mixrack audio sync i set its clock to internal and outputs port b:dante ch1 to mixrack inputs (exactly the same when i record). Then i set idr32 and t80 audio clock source to mix rack port b. I change ch1 preamp input to port b dante 1. Everything is green ticked on both ilives.
Now on dante controller my idr10 clock status is set to master and preferred master + slave to external word clock are also ticked. Primary link speed for both cards show 1Gbps. But when i route idr10 ch1 to reciever idr32, although it turns green to indicate that a connection has been established, audio from idr10 ch1 to idr32 ch1 does not pass through??
Help would be much obliged
Heldar
thank you
Thanks nicola
quote:
Originally posted by nicolaHi Heldar,
This is a known issue. At present the iLive does not display any information about Dante cards fitted in Port A of a modular surface. However, rest assured that the card fully works.
Remember you have to set up the Dante network manually using Dante Controller. Channels 1-32 will need to be transmitted between each device for local I/O. Ch63-64 need to be routed from the MixRack to the Surface for PAFL. Ch64 from the Surface needs to be routed to Ch64 of the MixRack for talkback. The Dante card in the MixRack has to be set as the preferred master clock and ‘Slave to Ext Word Clock’ should be ticked.
This leaves you 30 spare channels for recording if you wish.
Hope this helps
Nicola
A&H
