[MysteriumParticipant]

Hi Polly,
The video link below explains how to use FX on the SQ series mixers and is easy to follow. I understand how it is to be a performer trying to figure out a new digital mixer because I also fall into this category. I hope this helps and good luck with your gig.

Let me know if this helps.

CB

[MysteriumParticipant]

Thanks for the fast response ozdoc! I had been in the I/O patching screen a hundred times making routing changes and experimenting with the Rack FX trying to get this working. I finally got it working today by following your directions above and then dragging the FX4 Send strip to channel 16. Not sure if this is the correct way to go about setting it up, but it works so far. I truly appreciate the support!

Regards,

CB

[MysteriumParticipant]

Hi Alex,
Thank you so much for the response! I had seen that document before, but after seeing your response went back and gave it another read. As it turns out, I had everything on the SQ6 configured correctly. The problem was in ProTools with the MIDI Input Devices as I had SQ Emulation checked as well as the DAW controls. Once I unchecked that box, everything starting working as expected. Again, thanks for the direction…you saved me a lot of frustration.

Regards,
CB

[Author]

Posts