Trim and Gain settings

Forums Forums CQ Forums CQ troubleshooting Trim and Gain settings

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #126732
    Profile photo of ClebsClebs
    Participant

    I thought one of the preamp or ADC of my CQ12t was bad. Even at maximum gain, it was impossible to drive a dynamic mic upper than than the green “zone”, while it was possible with other inputs.
    If fact, few days before, I had to use the “bad” input as a digital channel, set some trim to -12db, and back the channel to analog input. At this step, It was not shown, but the -12db trim settings was still active.
    I had to put back the channel again as a digital channel, reset the trim to 0, and set back the channel to analog.

    Imo, trim settings can be retain while channel set in analog, but not applied in the channel sound chain

    #126736
    Profile photo of KeithJ A&HKeithJ A&H
    Moderator

    Hi @Clebs

    We agree, and this is usually what happens.
    There is a known issue listed in the release notes relating to this though (which we plan to fix in future), where a scene recall can cause the stored trim to be applied to an analogue channel.
    If this is not what you’re experiencing, please let us know.

    Thanks,
    Keith.

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.