Tie Lines vs IP direct out

Forums › Forums › SQ Forums › SQ general discussions › Tie Lines vs IP direct out

This topic contains 1 reply, has 2 voices, and was last updated by Profile photo of Gab Gab 4 years, 9 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • 2019/07/03 at 12:59 pm #84986
    Profile photo of Fabbabo
    Fabbabo
    Participant

    Hello folks,
    A quick question:
    Tie lines is basically a Direct out Post Preamp correct? The global direct out settings obviously will not apply to the Tie lines, what about the direct out level for the single channel?
    Cheers

    2019/07/03 at 1:40 pm #84987
    Profile photo of Gab
    Gab
    Participant

    Direct out and tie lines are always separate, direct out settings do not influence tie lines. tie line is the pure preamp signal, and is before the first possible direct out point which is post polarity and trim, as well as width on stereo channels.

    Sent from my iPad using Tapatalk

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.