SQ6 Won't Control DT168 Inputs

Forums Forums SQ Forums SQ general discussions SQ6 Won't Control DT168 Inputs

This topic contains 1 reply, has 1 voice, and was last updated by Profile photo of tourtelot tourtelot 1 month, 1 week ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #121427
    Profile photo of tourtelot
    tourtelot
    Participant

    I plugged my DT168 in my SQ6. That inputs with active P48 showed up on the DT168 from the last job. Everything is correctly routed both on the SQ6 I/O patch and in Dante Controller. I have plugged a P48 mic into an input on the DT168 and it shows up as working correctly on the SQ6.

    However, the input controls on the SQ6 are greyed-out and I can not turn the P48 off on any of the DT168 inputs.

    Both units have the latest firmware.

    What am I missing here?

    Doug

    #121428
    Profile photo of tourtelot
    tourtelot
    Participant

    So, false alarm. I had tried this early on but a second time unplugging and plugging the Cat cable into the DT168 brought the preamp controls back to life.

    Whew!

    D.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.