SQ6 Faders moving to -10db

Forums Forums SQ Forums SQ troubleshooting SQ6 Faders moving to -10db

Tagged: ,

This topic contains 1 reply, has 2 voices, and was last updated by Profile photo of Nips Nips 19 hours, 30 minutes ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #120554
    Profile photo of Welcomemattvo
    Welcomemattvo
    Participant

    Hi, I’ve noticed recently that if I move a fader anywhere above unity, when I then switch to a different layer or mix and back again, that fader moves to -10db. This happens on any mix, and includes the Master fader. I haven’t noticed this happening before yesterday when I did a fader calibration to try and fix another issue, so I’m wondering if that has caused this new problem?

    #121430
    Profile photo of Nips
    Nips
    Participant

    I also encountered this issue with my sq5 after updating my firmware to ver 1.5.10 I did fader calibration to try and correct it to no avail.. -10 db creates a big issue with my mix as I lose a lot of my level with my aux and mains.. hope somebody notices and help us with this issue..

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.