SQ On-board insert patch point

Forums Forums SQ Forums SQ general discussions SQ On-board insert patch point

This topic contains 1 reply, has 2 voices, and was last updated by Profile photo of mfusa mfusa 3 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #117071
    Profile photo of harrisonhal266
    harrisonhal266
    Participant

    Good day,

    Is there a way to move the on-board channel strip insert patch point from pre-aux to post-aux? Using Waves and musicians dont want to hear the plugin on their stereo IEMs being routed from the auxes so was hoping there is a way to move the insert patch point post aux. Can this be done?

    Thanks
    Hal

    #117074
    Profile photo of mfusa
    mfusa
    Participant

    I’m not in front of my SQ but I think what you are trying to do is adjust the aux signal tap point which should be doable. Check out page 40 of the user manual at

    https://www.allen-heath.com/content/uploads/2023/05/SQ_ReferenceGuide_V1_5_0.pdf#page40

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.