QU24: LCD, ºC….

Forums › Forums › Qu Forums › Qu troubleshooting › QU24: LCD, ºC….

This topic contains 3 replies, has 4 voices, and was last updated by Profile photo of Lee7 Lee7 8 years, 6 months ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • 2015/10/20 at 12:48 am #51491
    Profile photo of steven
    steven
    Participant

    After upgrading to 1.8, LCD backlight flashes a little;
    I restarted, disconnecting power, all right then.

    The maximum working temperature 70 ° C (23 room) is it right ?.

    What is most compatible DAW? Or recommended?

    Is it possible, buy faders chrome?

    VERY PLEASED WITH QU24. THANK YOU

    2015/10/20 at 6:18 am #51496
    Profile photo of [XAP]Bob
    [XAP]Bob
    Participant

    My screen did the same, didn’t check temp – but there was a definite pulsing of the screen.

    2015/10/20 at 12:46 pm #51507
    Profile photo of David J.
    David J.
    Participant

    Still I have not installed the new version 1.8 but my QU-24 operating temperature has always remained at 73’C, it is very hot. In contrast, it remains at 63’C QU16. I don’t know if it’s normal

    2015/10/20 at 2:16 pm #51517
    Profile photo of Lee7
    Lee7
    Participant

    The screen on my QU-16 has done that everytime I have updated the firmware, only lasts for a few seconds then never does it again until the next update.

    🙂

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.