Patching a CDM rack with DX168 on SQ

Forums › Forums › SQ Forums › SQ general discussions › Patching a CDM rack with DX168 on SQ

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • 2023/11/13 at 8:30 pm #116529
    Profile photo of JeroenAudioJeroenAudio
    Participant

    Hi all,

    This weekend I did monitors for a show. Setup: C3500 on FOH, CDM 64 rack on stage and an SQ6 for monitors on stage. We had no issues when patching the SQ and the CMD 64. However, when connecting an additional DX168 on the CMD rack I wasn’t able to pass any signal from the DX168 to the SQ. I thought I had to patch channels 65 and higher, but apparently that’s not correct as no audio passed. As we were running out of time we used an analog snake to the mix rack, but next time we would like to use the DX rack.

    Any suggestions?

    Best regards,

    Jeroen

    2023/11/14 at 12:16 pm #116542
    Profile photo of ScottScott
    Participant

    Depending on the DX socket used, you may need to patch beginning at 97, instead of 65.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.