Multi-Surface mode & virtual soundcheck

[RobbO]

I could have sworn I’ve done this before but I can’t seem to get it going.

I have a Dante card in my DM64, s5000 connected to the built in GigaAce ports, and Director acting as my s7000 at FoH. I fire up a multitrack session on my laptop and I get signal in Director but nothing on the s5000. If I repatch the Dante channels from 1-64 to 65-128 I see signal on the s5000 but not in Director and can not double patch them like the inputs are in the multi-surface template show.

Is there a way to share the Dante channels between two surfaces?

Thoughts?

[Anonymous]

Hi Rob,

In Director, go to: Select Channel –> Preamp –> Enable ABCD –> Assign Input to B –> B can be assigned to the mons desk S5000.

Kindest Regards,

Nicole

[Author]

Posts