Mid and Side

Forums › Forums › Qu Forums › Qu feature suggestions › Mid and Side

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • 2014/04/03 at 5:02 pm #38698
    Profile photo of Thunderbass1Thunderbass1
    Participant

    I would love to be able to monitor M&S mic setups. I regularly use these both on main stereo mics and acoustic guitar recordings.
    Cheers

    2014/04/04 at 7:07 pm #38741
    Profile photo of moonmoon
    Participant

    You can use a xlr splitter to feed the figure 8 microphone to two channels.
    Then flip the polarity on one channel. Pan hard left and right.
    Then your good to go.

    cheers,
    Mike

    2014/04/06 at 10:10 am #38774
    Profile photo of Thunderbass1Thunderbass1
    Participant

    Thanks Mike, nothing wrong with the conventional approach I agree, just a bit messy after getting used to RME totalmix in my laptop with built in M&S decoding.
    Moon on a stick would be handy too : )

    2014/04/06 at 8:05 pm #38800
    Profile photo of moonmoon
    Participant

    I record 2 mics in M/S configuration in to channel 1&2 on the QU-16, then on to digital Performer
    on a laptop. I throw on an M/S decoder and bring it back into the QU-16 for monitoring……..

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.