dual patching

Forums › Forums › SQ Forums › SQ general discussions › dual patching

Tagged: ,

This topic contains 1 reply, has 2 voices, and was last updated by Profile photo of ddff_lv ddff_lv 5 years, 7 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • 2018/09/02 at 5:01 pm #78257
    Profile photo of Lauren
    Lauren
    Participant

    Is there any way I can patch an input to multiple channels? I’ve done this in the past on yamaha and midas consoles but couldn’t figure it out on my sq5.

    Basically I want to take the kick drum which is plugged into the dsnake on input 1 and route it to multiple channels on the board, specifically channel 1 which I would use for my house mix and channel 33 which I would send to the in-ears so I can eq them individually?

    Is this possible on the sq5? If so, how do I do it?

    2018/09/02 at 7:26 pm #78267
    Profile photo of ddff_lv
    ddff_lv
    Participant

    Sure, you can. One input to any number of channels. Just go to the I/O patch page and put crosspoints where needed.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.