Can an SQ5 show file be loaded to SQ6?

Forums Forums SQ Forums SQ general discussions Can an SQ5 show file be loaded to SQ6?

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #113971
    Profile photo of WaihekeSoundieWaihekeSoundie
    Participant

    My local theatre has an SQ6 and I personally have an SQ5..
    What is the best way for me to copy / share a show file I created for my SQ5 to the SQ6? Will it load directly?

    Thank you

    #113972
    Profile photo of Søren SteinmetzSøren Steinmetz
    Participant

    It should load, providing the firmware versions match.
    ohh and remember the last 8 faders on each layer will not be populated until you make the layer assigns on the SQ6.

    #113977
    Profile photo of SQuserSQuser
    Participant

    I can also say that it works flawlessly.
    You can use your sq-5 stick and load the show into the sq-6 in the same way.

    #114007
    Profile photo of PapanatePapanate
    Participant

    As @sorensteinmetz said the show will load correctly – but you won’t get anything on the last 8 faders – like wise in reverse if you have information
    on those last 8 faders it will not be shown on your SQ5.

    #114043
    Profile photo of SQuserSQuser
    Participant

    Maybe still in addition:
    Of course, you can also prepare your show for the SQ-6 offline with the MixPad app and push the result from there or via a stick into the theater console.

Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.