GLD80 FX routing

Forums Forums GLD Forums Archived GLD Discussions GLD80 FX routing

This topic contains 3 replies, has 4 voices, and was last updated by Profile photo of byondo byondo 8 years, 9 months ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #23250
    Profile photo of songweaver
    songweaver
    Participant

    We just purchased the GLD-80 with the GLD-AR2412 digital snake. We have a couple of questions:

    1. We are using Aux’s for monitor mix, can’t figure out how to apply FX to Main L/R for certain channels and remove the FX from the Aux’s for those channels. At present when we apply the FX it affects all the Aux’s and the Main L/R. How do we fix this?

    2. How do you adjust recording level to record to usb feature, and how do you feed the recorded audio to the Main L/R on USB playback feature.

    Thanks in advance!

    Jordan

    #31145
    Profile photo of Stealth
    Stealth
    Moderator

    Hi Jordan

    quote:


    1. We are using Aux’s for monitor mix, can’t figure out how to apply FX to Main L/R for certain channels and remove the FX from the Aux’s for those channels. At present when we apply the FX it affects all the Aux’s and the Main L/R. How do we fix this?


    To assign/de-assign FX from the main mix, press the MIX button on the mains strip. then hold down the MIX assign button and press the FX return channels you wish to assign/de-assign from the main mix.

    To assign/de-assign FX from an Aux channel, press the MIX button on the Aux you wish to change the routing to. then hold down the MIX assign button press the FX return channels you wish to assign/de-assign from the main mix

    quote:


    2. How do you adjust recording level to record to usb feature, and how do you feed the recorded audio to the Main L/R on USB playback feature.


    To set the record level you can use a Matrix output to send the main mix to the USB record. The fader level for the matrix then becomes the send level to the USB record.
    to send the USB playback to mains, SEL a spare stereo input/group/Aux channel and select the channels source to be from USB.

    Regards
    Sam A&H

    #31314
    Profile photo of kelso528
    kelso528
    Participant

    Question: Are there plans in firmware updates to extend the delay times in the FX delays? 1.36 sec is a bit short for tap tempo applications that I need.

    #31320
    Profile photo of byondo
    byondo
    Participant

    Another related request: is there any hope to see group’s effect sends in the next firmware release (there are already the auxes but not effects)?

    Thanks in advance, regards.

    Massimo

Viewing 4 posts - 1 through 4 (of 4 total)

The forum ‘Archived GLD Discussions’ is closed to new topics and replies.