[canary]

Thanks Everyone,
Yes Stix and Scott. Yes I can easily move strips about so it’s no big problem in the great scheme of things. I’d just hoped it would recognise how things should be. Finicky old bu**er

[canary]

Thanks Gents for your replies. I can confirm that the software in both desks is current. An example of just one annoying problem encountered is: If I’ve set up input channels 1 – 20 across the 112 on Layer A and save to a memory stick and then attempt to load this into the 80, it will only show inputs 1 – 12. I realise there are physically less faders on the surface of the 80, but I had hoped that the remaining channels 13 – 20 would’ve appeared on Layer B. This does not happen.??

[canary]

Apologies to GCumbee for predictive text mis-spelling your name.

[canary]

Hi Chris. Thanks very much. A very good and useful tip and very well written. It made complete sense to an old analogue man!
Thanks again

[canary]

That sounds interesting Chris. Could I trouble you for a bit more detail of how you actually set this up please. Gumbo’s idea works as does insert on a single channel or mix. Thanks

[canary]

Old english colloquial term used instead of, and imho better than, mate, pal, buddy, mac etc

[canary]

Thank you squire

[canary]

Hi Mike,
I’ve sorted out the problem now, not by uninstalling/reinstalling iPad app, but by downloading GLD V1.5 software on to a completely clean memory stick and installing in to GLD 112 with satis results.
Why it worked ok on my GLD 80 and not the 112 I don’t know but happily all is well. Thank you for your offer of support

[canary]

I too am having problems with iPad unable to work. I’ve just upgraded software on gld80 and 112 to v1.5. The 80 and iPad work fine. When I try the 112 like other users, I get to admin/login and it goes to please wait. If I go to network on 112 it appears to acknowledge connection, but the app stays on please wait. I’ve tried removing app and reinstalling several times but to no avail.
Any clues please?

[Author]

Posts