I do have another question. I have 2 monitors that display content during our services via HDMI. Sometimes there are messages with audio that are play. How can I get audio from HDMI and bring that audio into the SQ5 while still sending on the video?
The board is new and I set it up. I know a lot of the main “stuff” on the board. What I can’t figure out is why if I select Aux 2 why it says Mtrx2 when I press view. Shouldn’t it say Aux2 as well?
I double check the mode. but all of my inputs are suppose to go to my MainLR. The only faders not going to MainLR are my outs to sound booth, stage monitor and to my live stream. I have to get those tomorrow night hopefully as tomorrow is a busy day at work.
For some reason, I do not have MainLR signal either. I do not show any “noise” on that fader. I have my MainLR routed in I/O to Local 11/12 going to my amp.
Here is hopefully a video showing my setup. I would think if I setup it up correctly, If my CD fader is down, I shouldn’t hear it on the stage monitor or any monitor unless it is PAFLed.
On my routing screen,Aux2 is on and set to Pre level 0, and the sound is coming thru regardless of the CD fader level. If I switch it to post fader, I get nothing and I brought up, CD, Stage and Main LR faders.
Thanks Mike. If I’m understanding and set everything up as described, I will have the PAFL on all the time even when listening to the general Main Mix. Correct?
