[GINO_ZHOUParticipant]

TheMAXX：
Thanks for the answer!
I use aux1-aux8 to control each speaker separately because I have 40 microphones of the same size. I allocate the volume of each microphone to 8 speakers, so that the volume of each microphone to the speaker can be controlled separately to avoid the feedback problem caused by the speaker of the microphone.
After the final test, I found that the AMM function could be used in the LR channel, but the AMM did not seem to work properly in Aux. Maybe there was a problem with my setting, but now I have solved all the problems of the microphone opening.
Thanks again for your answer and good luck!

[GINO_ZHOUParticipant]

In the AMM, the signal for each of my input channels is turned on, and the AMM is turned on, as you can see from the AMM channel bar (same as QU’s working state). I’ve read the directions, too. Passed aux1-aux6, pre-fade and post-fade were tried, but still not worked. The input channel putter was also tried at position 0, and now there is only one question about the sampling rate.

[Author]

Posts