[BarrettParticipant]

Well, since this console does not allow me to patch directly to the Slave unit output on stage, I had to gerryrig it with a patch cord from the Master Line 1 out to channel 48 and then patch the DR32/Slave to the ACE source ch 48… This is stupid beyond belief. How in the world is this right? Surely I’m just missing something. This is nuts.

I can SEE the Main Out if I choose the Master Rack. But that option is not available to the Slave. Why wouldn’t you want to ever send the mains to the slave?

If this is how Allen & Heath has designed this, I can never recommend one of these boards ever. I have 12 hours into figuring out this one problem so far. Read enough about the board to rebuild it from sratch. But apparently, its written in British… And me no comprende..

[BarrettParticipant]

Okay, I found the Outputs button that was sitting in front of my face all this time. Still can’t make it work.

I choose Outputs
Choose Slave, from the drop-down menu.
Then I choose the port (#G-8) that the main amps are connected to down on the stage and that’s where my luck ends. How do I get the board to output its mains to that plug? Good grief, this cannot be this difficult.

I tried several times to reset the board to factory default, but flipping those dip switches in the back of the T112 and rebooting did nothing to reset anything. I’m starting to question my sanity.

[BarrettParticipant]

I’m having the same issue. I tried to reset everything by flipping all the switches up and doing the boot and then down for the reboot and everything is still there. Nothing changed.

[Author]

Posts