soft keys

Forums Forums Qu Forums Qu general discussions soft keys

Tagged: 

This topic contains 9 replies, has 4 voices, and was last updated by Profile photo of [XAP]Bob [XAP]Bob 5 years, 11 months ago.

Viewing 10 posts - 1 through 10 (of 10 total)
  • Author
    Posts
  • #47767
    Profile photo of Creator
    Creator
    Participant

    Is there a way to start and stop recording using the soft keys once it is armed? I’m not sure if it is possible to use the soft keys for that was just wondering.

    #47768
    Profile photo of JD
    JD
    Participant

    Bump.

    #47771
    Profile photo of [XAP]Bob
    [XAP]Bob
    Participant

    Take a peek at the manual, section 10.5

    #47781
    Profile photo of Creator
    Creator
    Participant

    Thank you Bob , but an FYI it’s 8.5 there is no 10.5 in the manual. The only thing under section 10 is iPad stuff

    #47782
    Profile photo of Andreas
    Andreas
    Moderator

    Chapter 10.5 in the Current Manual is titled Control Setup – Softkeys and the requested information is exactly on that page.

    #47785
    Profile photo of Creator
    Creator
    Participant

    OK then. I had an old manual and I retract previous statement, except the thank you to Bob, and now to you as well. Did not know there was a new one

    #47788
    Profile photo of Andreas
    Andreas
    Moderator

    Manual is always updated with each firmware release.

    #47791
    Profile photo of Creator
    Creator
    Participant

    Good to know. Makes printing off a physical copy hard though

    #47792
    Profile photo of Andreas
    Andreas
    Moderator

    …Makes printing off an in-depth physical copy non-sense, it will outdate with next firmware upgrade. Personally never thought about looking into it.. 😉

    #47800
    Profile photo of [XAP]Bob
    [XAP]Bob
    Participant

    I always have the latest manual on my tablet. Any ereader would work, but there are lots of colourful pictures.

Viewing 10 posts - 1 through 10 (of 10 total)

You must be logged in to reply to this topic.