QU 16 Using Mixes

Forums Forums Qu Forums Qu troubleshooting QU 16 Using Mixes

This topic contains 3 replies, has 3 voices, and was last updated by Profile photo of ShyamM ShyamM 6 months ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #105926
    Profile photo of ShyamM
    ShyamM
    Participant

    Hi A&H’ers

    I have my L&R Front of House set up however want to put two stage speakers which have the same mix as L&R FoH including effects (reverb and delay) – I need Mix 1 to be exactly the same as my L&R, is there a way of doing this without having to manual adjust the faders to replicate the L&Rs.

    Many thanks!
    Shyam

    #105927
    Profile photo of BCEly
    BCEly
    Participant

    Why not use the Alt Out rather than Mix1??

    #105935
    Profile photo of Mike C
    Mike C
    Participant

    Alt Out with L R selected as the source would do it.

    Using a mix would give you independent output EQ to the stage monitors that you may need.

    To use a mix set the mix to post fade and post all, select the mix and then set all the send level on all channels and FX returns to unity. Do that the mix output balance will track all the moves you make on the main left right mix.

    #106024
    Profile photo of ShyamM
    ShyamM
    Participant

    Thank you! Going with the ALT OUT – much appreciated

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.