Q-pad and board different values

Forums › Forums › Qu Forums › Qu troubleshooting › Q-pad and board different values

This topic contains 0 replies, has 1 voice, and was last updated by Profile photo of jport jport 10 years, 1 month ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • 2014/03/27 at 6:53 pm #38591
    Profile photo of jport
    jport
    Participant

    Just noticed that my q-pad and the board display have different values for gate, compressor and PEQ.
    Not a huge difference but for example all 4 PEQ frequencies are different on the board than on the q-pad. Same with the compressor, attack times and release and threshold are all just a bit different on one than the other. If I adjust the values on one unit (say q-pad) the board changes as well, but the values never really perfectly line up on both units.

  • Author
    Posts
Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.