Preamp status and scenes

Forums › Forums › dLive Forums › dLive General Discussions › Preamp status and scenes

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • 2017/06/30 at 12:55 pm #64082
    Profile photo of ddff_lvddff_lv
    Participant

    Is it just me or Gain, phantom and pad are not stored in scenes?

    ddff

    2017/06/30 at 5:55 pm #64087
    Profile photo of MacMac
    Participant

    Might check your “recall filter” settings.

    2017/06/30 at 7:51 pm #64088
    Profile photo of ddff_lvddff_lv
    Participant

    Believe or not, could not find. Just Trim, Left/Right, Stereo image and preamp model. Or I need better glases.

    ddff

    2017/07/02 at 2:10 pm #64109
    Profile photo of ddff_lvddff_lv
    Participant

    I went throuhg reference guide 1.5 – https://www.allen-heath.com/media/dLive-Firmware-Reference-Guide-V1.5.pdf
    and Apendix B 13.1. Scene memories (page 99) says:

    Scene memories store the following parameters and settings:
    Input channels
    * Preamp Gain, Pad, +48V
    * Digital Trim, Polarity
    * Stereo Image
    * HPF and LPF Filters
    * Insert In/Out and operating level

    But there is no way I can make it work in reality.

    ddff

    2017/07/03 at 12:32 pm #64126
    Profile photo of ddff_lvddff_lv
    Participant

    OK, just found it – the preamp safe is in preamp section of channel. And in the global safes it is called Left.

    ddff

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.