LCD Flicker after update

Forums › Forums › Qu Forums › Qu troubleshooting › LCD Flicker after update

This topic contains 1 reply, has 2 voices, and was last updated by Profile photo of eotsskleet eotsskleet 10 years, 5 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • 2013/11/11 at 3:32 pm #35980
    Profile photo of jraymond
    jraymond
    Participant

    I’ve noticed that each time I’ve updated the firmware on my Qu-16, after the mixer reboots itself, the LCD screen flickers. It’s almost like the refresh rate is not set correctly. If I shutdown down through the menu and power cycle the mixer after this, the screen looks normal again from then on.

    It’s not a major problem but I wanted to report it and see if others have had a similar experience.

    2013/11/11 at 4:56 pm #35981
    Profile photo of eotsskleet
    eotsskleet
    Participant

    I had the same experience, but after a new reboot the screen worked well, so no further Problems (i hope so)!

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.