FX to Out 1-6 possible?

Forums Forums CQ Forums CQ troubleshooting FX to Out 1-6 possible?

Tagged: 

This topic contains 3 replies, has 2 voices, and was last updated by Profile photo of BubbaJ BubbaJ 1 month, 1 week ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #121560
    Profile photo of Bassman74
    Bassman74
    Participant

    Hi,

    I own a CQ20B and I have not found anoption to control the FX return level of a shared FX to the Out 1-6.
    There is the “FX Level to LR” controll, which is obvious.
    The “FX Send Level” control left to it is unclear to me.

    I it’s not posible today, I would request an addition Tab with “SENDS FROM FX Unit” to controll the levels on the Out 1-6.

    Attachments:
    You must be logged in to view attached files.
    #121572
    Profile photo of BubbaJ
    BubbaJ
    Participant

    Have you checked out p. 48 in the manual? Looks like from the Processing tab, you can get to ST INPUTS / FX tab, pick your FX unit channel, then send to pick LR our outputs 1-6…

    #121575
    Profile photo of Bassman74
    Bassman74
    Participant

    That’s it, thank you BubbaJ, I found the FX to Outputs sliders in the processing tab.

    I was playing around with the MixPad Software without having the CQ attached. In this case only ST IN / USB / BT is showing up in the processing page, but not the four FX units.

    #121580
    Profile photo of BubbaJ
    BubbaJ
    Participant

    Glad to hear it! It’s funny – I actually had the same question a month or so ago and I had forgotten to look it up. So it was helpful to hear from you that it did the trick.

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.