FAT32 errors

Forums › Forums › Qu Forums › Qu troubleshooting › FAT32 errors

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • 2014/02/19 at 5:32 pm #37824
    Profile photo of Yorkshire PuddingYorkshire Pudding
    Participant

    Hi,
    Using both the V1.2 and 1.3 firmware when I format a drive with the QU16 and then attach it to a Windows box & run chkdsk Windows reports that there are FAT32 errors on the drive.
    I’ve tried a memory stick and a 500GB hard disk, both with the same results.

    Is it OK to fix the errors with Windows – or will that confuse the QU16?

    knowing there are errors makes it hard to trust QuDrive for important recordings…

    2014/02/21 at 4:40 pm #37867
    Profile photo of mamericamamerica
    Participant

    Are the devices on the list that A&H tested and approved?

    2014/02/21 at 5:34 pm #37868
    Profile photo of Yorkshire PuddingYorkshire Pudding
    Participant

    The exact models are not on the approved list. However I doubt that “not on the approved list” is the issue here as the symptoms are consistent across a variety of devices. Reading/writing to the hard drive does work OK – it’s just that the FAT32 partition table that the QuDrive formatting is producing is slightly iffy…

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.