Ext In tap point

Forums Forums dLive Forums dLive General Discussions Ext In tap point

This topic contains 1 reply, has 1 voice, and was last updated by Profile photo of ThisIsAnAudioAccount ThisIsAnAudioAccount 2 weeks, 6 days ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #110820

    Is it possible to select an Ext In: source select of an aux and tap into that channel pre processing?

    I am wanting to duplicate a stereo Aux Mix to be processed differently from Mains and be fed to a broadcast mix. In some initial testing, if I send pink noise to Stereo Aux 1 and set the Ext in of Stereo Aux 2 to Stereo Aux 1, then PEQ changes on Aux 1 affect the sound of Aux 2 as well. Is there a way to select pre processing Source point when selecting a source? This would be similar to selecting source point from the routing page (see image.)

    #110821

    Images were too large in the OP. Here they are.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.