Connecting 2 SQ's

Forums Forums SQ Forums SQ general discussions Connecting 2 SQ's

This topic contains 1 reply, has 2 voices, and was last updated by Profile photo of Tobi Tobi 11 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #112989
    Profile photo of RoB
    RoB
    Participant

    Hello,

    i know that this topic exists a lot, but i can’t find the correct answer for me:

    i want to connect an SQ5 (MON) and a SQ6 (FOH). If it’s possible i want to connect without stagebox because the band only has 13 inputs.

    I’m able to rout the input from MON to FOH, this works. But how do i rout back the signal. I don’t know how i have to do the patch in the console and i can’t find help.

    Thank You all for your help!!

    RoB

    #112990
    Profile photo of Tobi
    Tobi
    Participant

    At FOH:
    Go to “IO Patch”, then on the left side select “Outputs->Mix Out”. On Top select either SLink or IO-Port, as you have connected. Then send the Outputs back through the same link as you get the inputs.

    At Monitors:
    On the left side choose “Tie Lines->Slink (or IO Port, as you have connected)”. On Top choose “Local”. Then Tie Line together the signal you send from FOH to one of the local ports.

    Best Regards,
    Tobias

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.