Mark, just an add : A&H says “…up to 100m over a single cat5 cable…”
So, max speed is 100MB, isn’t it? I think I can somewhere going through a wifi network
wich can actually go to 200MB.
OMG : number of channels x speed of each of them…for stream 🙂
Why did I tried to do this? I had a dream, but I’m awake now Mark. Many thx for giving me the light!
thx Ryan!
To control Qu32 through my router then wifi repeter with my tablet, it’s just perfect.
I know I can have a range long enough from FOH to stage.
Even tried this, for Qu32 controlling -> rj45 -> CPL -> electric network -> CPL -> router -> wifi -> tablet -> works perfectly
But I just tried to send rj45 DSnake to my router, then repeter with rj45 to AR2412
and even in the same room, nothing coming from DSnake port to AR2412.
So I also tried with CPL, nothing at all.
Anyone did ever tried to do this?
File too big.
Well it was the small wire inside the console slot.
OMG small pins in network socket were not in their good location, look :
pin 1 & 2 on second row and 5,6 in the 6th
So i took my best glasses to zoom in 🙂 see attached pic
and replaced them in their own row 1/1 2/2 etc… and then : TADAAAAM everythings fine now
Next to this, back to router : each device detected
Even with MixStation 1.82 or Qu-you : all is ok, working perfectly
Have a good day.
for sure Mark!
Still stucked with this connection…I tried to plug my Qu on my Internet box Lan4
still nothing from there…Console light is on ‘blinking’ as if it was looking for something
but not connected as device in box or router.
Any idea please? Is the cable can be wrong one again? I just find 4 cables and only 1 set the network light on console ON
Thx for sharing this.
Here my Qu32 is plugged into Lan connector from network slot. I really think it’s ok for this point.