Zed-10 home setup

Forums Forums Other A&H products Zed-10 home setup

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #106358
    Profile photo of falilampafalilampa
    Participant

    Hey All, got my hands on a Zed-10 recently.
    My main question is regarding the setup – how am I able to send my PC’s sound to the mixer? I would like to listen to stuff from my PC and send them out via the mixer to my monitor speakers.
    I have tried a Y-cable 3.5mm jack from my PC to 2×6.3mm jack monos, and plug those monos into ST-2 as inputs. Not working.
    Also tried the USB connection, from my PC’s regular USB-B port to the Zed’s USB-A and that does not work either.
    ST1 as input for my Pioneer RX1 works fine. Sending out via Main Mix Out L&R to Yamaha monitors. Using Windows 10.

    I might be in the wrong here, looking for a bit of help. Thanks a lot.

    #106361
    Profile photo of Mike CMike C
    Participant

    On you computer does the ZED show up as a sound output device?

    You also can not have anything plugged into the ST2 jacks, doing that will override
    the USB playback input.

    #106453
    Profile photo of falilampafalilampa
    Participant

    Computer was at fault: thanks to Windows, the new upgrade rendered my soundcard spaghetti – had to reinstall audio drivers to make the Zed appear. Works fine now

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.