Mixer Config with Mono channels

Forums Forums GLD Forums GLD feature suggestions Mixer Config with Mono channels

This topic contains 0 replies, has 1 voice, and was last updated by Profile photo of lithiumfun lithiumfun 7 years, 6 months ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #37568
    Profile photo of lithiumfun
    lithiumfun
    Participant

    Two things.
    1. I’m not sure if the fact that mono busses come only in pairs is a software necessity or a leftover from older audio equipment, but it would be helpful if they could be assigned individually. This would prevent:
    2. With mains in LR+M, one mix gets used for the mono out and another disappears into the ether. So where I only get the functionality of one mix, I have to use up two busses.

    I run too many mixes to keep track of in our system, so the loss of one is actually hard to work around. With so many different mixes needed, even one more could help.

    Thanks!

Viewing 1 post (of 1 total)

The forum ‘GLD feature suggestions’ is closed to new topics and replies.