IO port screws

Forums › Forums › GLD Forums › GLD general discussions › IO port screws

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • 2016/03/22 at 11:00 pm #54711
    Profile photo of I amI am
    Participant

    Can someone please tell me what kind of screws are in the IO port lid?

    2016/03/23 at 7:48 am #54714
    Profile photo of ShowtimeShowtime
    Participant

    Something torx 8-9-10 that range

    2016/04/06 at 5:46 pm #54981
    Profile photo of tenderboytenderboy
    Participant

    I don’t remember the size, but still remember vividly how I hated A&H when I tried to install my madi card.
    I went through 3 different tool boxes and another 3 special toolboxes for small screwdrivers…but after nearly 90 minutes and none of the about 50 torx we had worked…the torx of the leatherman of my colleague finally worked

    2016/07/31 at 1:52 am #57459
    Profile photo of MikolMikol
    Participant

    Its a T8. Just did a Dante card install 2 weeks ago and had to run to the store. My bit set only went as low as T10… ugh.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.