[tspad1960Participant]

A quick thought on this topic would be the following about the surface.

1) Some means to adjust the led brightness of the channel strip independant of the brightness of the virtual write-on strip above the fader. Under low lighting conditions, once you dim the leds on the channel strip so they are not blinding you, the colors of the virtual strips are gone.

2) Possibly an additional display same type as the virtual write-on strip above the channel strip which displays the channel name of the selected channel in a large font.

tspad1960

[tspad1960Participant]

I am new to the iLive, but I had a similar situation when first evaluating the software.
When I first installed it, it did not seem to matter what I selected on the initial screen. I think what I had to do was to go into the scenes area and recall the surface and mixrack scenes to make the software remember the configuration. This is the same that you would do on a real system when creating a new show.

After this it seemed to remember what I had selected. If you dont have the scenes for the configurations, use shows to load a new show from a factory template.

tspad1960

[Author]

Posts